How to measure the bracelet - bangle size?

How to measure the bracelet - bangle size?

How to measure the bracelet size?

Measure around your knuckles for closed loop bangles. Closed loop bangles have a rigid shape and must slide over your hand when you put them on. If you’re measuring your wrist to find the right bangle size, then hold your hand in front of you with your palm face up. Move your thumb to touch the tip of your pinky so your hand is the same shape as it would be when you put on a bangle. Find the circumference of your hand around the knuckles
Be careful not to move your pinky or else you’ll have an inaccurate measurement.

 

MEASURING YOUR WRIST FOR BANGLE

STEP 1: Close your fingers together and bring your thumb to your little finger (as pictured). Pretend that you were putting on a bangle

STEP 2: Using a strip of paper or tape measurements, wrap it around your hand at the widest point.. If you are using a plain strip of paper, mark your size with a pen on that paper. Then measure that paper strip with a ruler. That would be the circumference of your hand.

STEP 3: Compare your hand circumference to the chart below. Purchase a bangle with diameter that is the next size up from your actual hand measurement. Refer to the appropriate measurements in below  bangle charts.

 

Leave a comment

Please note, comments need to be approved before they are published.